4k govener spring kit
#1
#2
I believe its much the same as the 3k spring install.....PDR governor spring installation You should get a decent set of instructions, depending on where you get them from.
You also need to put in the HD valve springs.
You also need to put in the HD valve springs.
#4
Pretty easy. Just make sure to put the nuts on the same distance. Use a set of vernier calipers to measure the stud stick out.
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck
#6
Pretty easy. Just make sure to put the nuts on the same distance. Use a set of vernier calipers to measure the stud stick out.
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck
#7
Pretty easy. Just make sure to put the nuts on the same distance. Use a set of vernier calipers to measure the stud stick out.
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck
4K is the same as a 3K with one extra spring in the pack.
And if you do it right, you'll be putting in 60# valve springs. Otherwise the valves will float at around 3800 RPM.
Good luck