4" exaust
#1
4" exaust
I've got a 97 dodge my factory exaust is all jacked up.. a buddy of mine put a 5" on his 06. He give me his factory one. but I didn't get to it before he cut it all up gettin it out. about the only useable piece is the one over the rear axle. has anyone else done this? I know i need a 4" down pipe and some 4" to go back to meet the axle piece. anything i'm missin here?
#2
Clamps and hangers if they're not on the old pipe. Unless you plan on welding it, then forget the clamps. I think the pipe for over the axle is $50 or so from summit in 4". If I had welded mine instead of clamping it, I think I would've been a hair over $150. That's including the downpipe, welding (exhaust shop) and a 4" tip.
#7
hey max, i just took stock convertor and exh off my 98 the other day if ur interested, oh hell i have the complete exh system and didnt cut anything. included if intersted could whatever banks stinger? is. i think it was a downpipe, then after cat 3.5" system. i know muffler says banks on it and down pipe looks newer. i did keep it all if you need something i will look for reply..pm..
Thread
Thread Starter
Forum
Replies
Last Post
ebg2g
5.9 Liter CR Dodge Cummins 03-07
1
03-29-2015 06:15 PM
01cummins4ever
24 Valve 2nd Gen Dodge Cummins 98.5-02
4
01-12-2015 11:33 AM