Super b special
Thread Starter
|
Diesel Fan
Joined: Sep 2009
Posts: 79
Likes: 2
From: GlenRock
Sent from my iPhone using Tapatalk
Thread Starter
|
Diesel Fan
Joined: Sep 2009
Posts: 79
Likes: 2
From: GlenRock
Yea it is, brand new super b special. The waste gate arm was pretty close to my oil drain though when I installed it...I might have to check to make sure it's not hung open
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Thread Starter
|
Diesel Fan
Joined: Sep 2009
Posts: 79
Likes: 2
From: GlenRock
In my old afc they were swapped around, but I had a new afc put on the when the pump was benched because the pre boost screw was seized up. So I believe they should be should be stock, I have to pull it off and look at it. I'm not even sure if he put my old foot in, because that was ground down at some spots.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Thread Starter
|
Diesel Fan
Joined: Sep 2009
Posts: 79
Likes: 2
From: GlenRock
Well I had extra time on my lunch break to pull the afc off an look inside.
The fuel plate was the whole way forward. The afc foot was brand new un-molested. The washers at the rear of the afc looked original. And the pre-boost screw was in further than I thought. So I slid the plate back to the half way point and backed to pre-boost screw out until it just touches the foot.
Drove it home...still smokes like a b*tch.
Sent from my iPhone using Tapatalk
The fuel plate was the whole way forward. The afc foot was brand new un-molested. The washers at the rear of the afc looked original. And the pre-boost screw was in further than I thought. So I slid the plate back to the half way point and backed to pre-boost screw out until it just touches the foot.
Drove it home...still smokes like a b*tch.
Sent from my iPhone using Tapatalk
this is your problem
full cuts
.120 holders
.093 lines
370 injectors
#0 plate
all these add up to a horribly tuned smoky pig. no other way to say it. put some injectors that are worth a crap in there, a #6ish fuel plate, atleast match the lines with .093 holders. make a nice complementary system or it will always make you look like a tool when you go out for a drive. the AFC is a fine tune, you are so out of tune it wont matter what you do it will smoke.
full cuts
.120 holders
.093 lines
370 injectors
#0 plate
all these add up to a horribly tuned smoky pig. no other way to say it. put some injectors that are worth a crap in there, a #6ish fuel plate, atleast match the lines with .093 holders. make a nice complementary system or it will always make you look like a tool when you go out for a drive. the AFC is a fine tune, you are so out of tune it wont matter what you do it will smoke.
Thread Starter
|
Diesel Fan
Joined: Sep 2009
Posts: 79
Likes: 2
From: GlenRock
Well I figure the full cuts were a great deal of the problem. Thought about going down to an .024
I didn't really think there was an issue with 370 injectors
Sent from my iPhone using Tapatalk
I didn't really think there was an issue with 370 injectors
Sent from my iPhone using Tapatalk
