Holset HX60 over HX40...
#21
I think it's a good setup, because i was going to do a HX52 over a HX35, but the HX35 has such a small exhaust housing that it would make crazy drive pressures...
I'm thinking that since both HX40 and HX60 are non-WG and have big exhaust housings this will clean up much better and still have the EGTs in order since i have the 4k GSK...
I'll just start off in 1st gear if i have to tow heavy and keep them breathing... no low boost smoke hauling with something heavy...
---AutoMerged DoublePost---
How much should i raise the pop? they're set at 260bar... should i go 20bar up?
I'm thinking that since both HX40 and HX60 are non-WG and have big exhaust housings this will clean up much better and still have the EGTs in order since i have the 4k GSK...
I'll just start off in 1st gear if i have to tow heavy and keep them breathing... no low boost smoke hauling with something heavy...
---AutoMerged DoublePost---
How much should i raise the pop? they're set at 260bar... should i go 20bar up?
Last edited by angelic0-; 09-28-2012 at 11:32 AM. Reason: Automerged Doublepost
#26