I had a deal I coud not let go on a 2005 RAM 3500 today, so now, it's mine !

The engine have a bad cylinder, smoke when it's cold and lots of blowby, bad injector ? broken ring ? melted piston ? I dont really care !

I plan on swapping my 2001 built Ppump 24 valve engine in the new truck.

The question is, what do I need to do to get the electronic (cluster and factory gauges) to work ?

Thanks

 

as far as the electronics go i dont know but im just lettin you know that whoever built that motor done an A class job man. props on that set up

 

I think you keep the common rail ecm so it can read the sensors and send the info to the gauges. Get a hold of Zach West,he is a member on here and is working on putting a 12 valve in his '03.

 

Thats really sweet! hope it all works out perfect bro!

 

Thanks LoneOakCummins21, It's always nice when somebody tell's you that you've done a great job !
Especially after over 600 hours of work to get the thing to run and look like this !!!

The engine was built by me a couple years ago, so far so good !
Still all together and in one piece, and see 70 lbs of boost mostly everyday !!!