i just replaced all the headlights brake lights & taillights on my 04 2500 & this morning when i went to use my left blinker it would say blown light i got out & checked it worked fine but anytime i use my left blinker my dash says its out & starts beeping till i use my right blinker then it goes back to normal,none of my fuses are blown none of the wires are cut & the lights are new,anyone know how i can get it to stop saying my lights out or make it stop beeping?

 

Hows the socket look itself? clean? bulb loose?

 

sockets clean new bulb it isnt loose or anything

 

Check the connector at the tail light, I had one that pushed the pins out and resulted in an intermittent turn signal and lamp out light.

 

also pull bulb and turn it over in socket mine was doing this and turning the bulb over took care of it

 

big-cs idead worked thanks yall

 

Anyone know where the piezo buzzer that makes that sound is? Everything is good, but it is driving me nuts. I flipped every bulb three times and it still beeps!!! Any help would be appreciated...