Hey, buddy of mine just got an early 07 Cummins, with the 5.9; it's a 1 ton fleetside, and was trying to figure out what all the specs on the truck were...I've done some looking around a couple of sites, but haven't been able to find a whole lot out...was hoping if I posted up what I needed, if you guys could help me out? Thanks!
Turbo (type and specs on the turbo)
transmission (it's a 6 spd, so I'm assuming it's a G56, but just needed verification)
axles (I was thinking D60 front, and AAM 11.25 rear, but I could be waaay off on that one)
exhaust size (IIRC, the early 07's had a factory 4 inch exhaust)
I think that's mainly it, but any other info you guys think would be good to have, I'd appreciate it. Thanks!

 

Yes it would be a g56 trans, dana 60 front, and aam 11.24 14 bolt, 4 inch exhaust as well, and the engine should be a 325hp 610tq, turbo is a he351 non vgt i beleive

 

Awesome, that helps out a lot. Thanks!

---AutoMerged DoublePost---

Shoot, just remembered, one last question...
transfer case....is it either the nv271 or 273 (i think that's the case numbers...)? thanks again!

 

I think these a 273 or something the 271's where a second gen one i beleive

 

If you take your VIN# to your local Dodge dealer the service desk will print off the options\spec sheet for you....at least mine did.

While you there have the service desk print you out the maintenance history.

 

Ditto That.