ABS light
#1
#3
i did not get any brake work done and as far as the scanner the check engine light is not on will it still pull up or do you need a different scanner or is there a different way to hook up and as far as tapping on the sensors are you refering to the ones on the front brakes because i did replace the abs speed sensor in the rear end already.
#4
It depends on the scanner you have! The scanner will pull the code for the abs as long as the light is on. The front brake sensors are not accessable. You will have to pull the tires off. After you clear the code the light will stay on. you will have to drive it around the block to reset it. If the light doesn't go out there is still a problem.
The following users liked this post:
dgroves82 (02-08-2010)
#5
ok so i had a buddy of mine with a fancy snap on scanner scan it and it says open circuit on right front abs sensor. now he said if i have to replace the sensor i have to replace the wheel bearing as well. all the local parts houses say that the sensor is NOT on the bearing but the excitor ring is i am gonna go pull all of it apart to see what is going on with it but has anyone heard that you HAVE to replace the wheel bearing. and most importantly thank you all for the help.
#7
ok so i took everything aparttonight and did not find any broken wires or anything however next to the silver pick up there is a crack in the plastic that is exposing cooper? wires so i am assuming that it allowed water in it and shorted? out i am gonna call the dealership tomorrow and get the sensor and will ask them if i "have to" replace the wheel bearing i just really hope that fixes it we are expecting up to 8 inches of snow and even now it stops fine i would really like to have my abs before the snow.
---AutoMerged DoublePost---
gotter fixed had a cracked abs sensor dont know how it happened but it was cracked that you to all that helped.
---AutoMerged DoublePost---
gotter fixed had a cracked abs sensor dont know how it happened but it was cracked that you to all that helped.
Last edited by dgroves82; 02-08-2010 at 07:59 PM. Reason: Automerged Doublepost
#9
i have an 05 3500. my abs light came on 1 week after i installed an edge atitude w juice(not saying that had anything to do with the upgrade) but i keep blowing the fuse under the hood. i had the local diesel guy put a scanner on it and no codes showed. just looking for any ideas as whats causing this. any help in appreciated.
#10
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
1
01-05-2016 12:03 PM