OK what else could drive me nuts today? She starts to sputter during light throttle and these codes pop up, 0341 and 0336, PDA said both were Crank shaft position sensor. Any suggestions ladies and gentleman? 03, 2wd, auto, dually, 145k miles, banks 6gun, cold air, open exhaust.

 

Mine did kinda the same thing. I called Banks and they sent me a noise filter for free just had to pay shipping and code never came back again

---AutoMerged DoublePost---

They said this filters out the vibration caused by it? I don't know but it worked very easy install too only took about five minutes

 

mine does not sputter but i get that stupid error all the time i just reset it and it goes away

 

Crankshaft sensors that repeat their selves need to be checked! Does the MIL kick even with the banks products un-hooked?

 

Mine has not come on again since i got the noise filter from Banks. I have put about 7500 miles on it too and no problems or codes yet

 

Does it with and without the 6-gun! Waitin on a new sensor to come it right now.