getting a scan tool today. hope that works.

 

The scan tool wont do anything. Its the data the scan tool provides that will allow you to find your issue. Maybe communication or ecm related maybe mechanical, who knows. Its all about interpretation of the data.

Sent from my SCH-I605 using Tapatalk 2

 

what do you mean the scan tool wont do anything? It will give me the codes I need, and clear them. Your comment is slightly confusing? we found out it was the crankshaft sensor.

 

Lol thats my point. The scan tool only gives you data. Interpretation is key.
A code doesn't mean the sensor is faulty however without an oscilliscope it would be hard to determine if a waveform issue is present. If you test for power and ground at the sensor with a good reading on a loaded circuit, replace it and it still won't start you can then diagnose further. You can also use a data pid to determine of the computer sees engine rpm.

Sent from my SCH-I605 using Tapatalk 2

 

we have a spare sensor. we also called a diesel shop in town, told them the codes so we will change it today. they agree it sounds like a crank sensor. wont take but a few minutes to change and try.

 

Subed

Sent from my HTC6435LVW using Tapatalk

 

WEll we have a new question maybe you guys can help with. I forgot to mention one thing in all this. The motor came out of a MANUAL truck, and we put it in a AUTOMATIC truck. we used the engine wiring from the manual truck, we think this may be the problem, found a plug by the transmission, we compared it to a friends automatic truck and it looks like it goes in to the engine wiring, but we don't have a plug on this wiring. so the question is, were the wiring harness' different between the automatic and the manual? we think this may b ethe problem.

 

yup!

 

ok. so is there a separate wiring harness for the automatic transmission? or is it all in one? we are also having a problem locating one. any ideas?

 

I think its all one harness