No power to lift pump
#1
No power to lift pump
I Have a buddy who just bought a 99 cummins. ran great whent and changed the fuel fillter drove a week after bought a hyper tech chip and installed it. drove it back home and put about 100 miles on it that day or more. the next day the truck started drove about 15 ft parked to let warm up. and then died. we had a hard time to get the chip back off. couldnt call over hyper tech on thanksgiving. the next day finally got the chip off after a long fight. still wouldnt start. check all the fuel and used a very little bit of ether and started right up and used it the whole day with no problem. the next day started and died again. we never put the chip back on. we thought it was a lift pump, whent to replace it out the tank. i tested the one in the tank before i pulled it, works fine. i just jumped it with a battery. i check all the relays seamed to be fine. some threads show it could be a Crank postion sensor or maybe a Map sensor. im going to make shur the batteries are charged good and thight. they did start to die off. i'm thinking map sensor b/c of using ether, first time didnt use much 2nd time alittle more then we stop
#3
#4
i ant getting any fuel pressure since it ant even coming on yet. where should i check it at? top of the fuel fillter? im going to check for codes here in a sec. also call hyper tech to see if they have to reflash the chip
---AutoMerged DoublePost---
code p1693 and u3efe
---AutoMerged DoublePost---
code p1693 and u3efe
Last edited by jimv01; 11-29-2011 at 04:29 PM. Reason: Automerged Doublepost
#6
Thread
Thread Starter
Forum
Replies
Last Post
Renteria1217
24 Valve 2nd Gen Dodge Cummins 98.5-02
4
04-16-2015 11:38 PM
klein444
Chevy/GMC 6.2L and 6.5L
2
02-21-2015 10:33 AM