Front Axle and 4X4 light Problem
#1
Front Axle and 4X4 light Problem
Can any one help???
I replaced the ball joints on my truck today (So I pulled out the axle half shafts)and after every thing was done took it on a test drive. And OH NO My 4X4 ligh is on, on the dash and the truck is in 2 wheel drive. I drove around put it in 4 high then 2 wheel then 4 low then 2 wheel and it wont go away. Also when I got home and jack up the front end to check bouth tires spun on there own w/ truck in park But the front drive shaft was spinning. So is there any help out there???
I replaced the ball joints on my truck today (So I pulled out the axle half shafts)and after every thing was done took it on a test drive. And OH NO My 4X4 ligh is on, on the dash and the truck is in 2 wheel drive. I drove around put it in 4 high then 2 wheel then 4 low then 2 wheel and it wont go away. Also when I got home and jack up the front end to check bouth tires spun on there own w/ truck in park But the front drive shaft was spinning. So is there any help out there???
#2
#4
#6
#8
If you got it back in there it should be in place, not much of a chance for error on this project, it's either there or it's not. If it slipped out of place I don;t think your bolts would have gone through it. Haven't messed with it in a few years but I think the bolts pass through it if i remember right.
#10
a weak spot in your vacuum lines is under the t case where the metal lines come up and join to the plastic ones they have a big goofy rubber deal that is easily made better with about 2- 3" pieces of 1/8" vacuum lines. If they come disconected, it will leave your front end engaged. This is a really good way to have to have your front driveline rebuilt.