You need to get this thing fixed enough to get back to OK so we can take a look at it.

Good Luck Levi

 

so the only people around here that can get the part is a dodge dealer and the part is 53.00 does that sound right?

 

From Dodge it's a lot higher then it was when I bought one a few years ago but I never doubt any stupid prices from Dodge. It will be cheaper from Cummins.

On the good side, even if it's not the problem you need to change this fitting when you change the IP anyway so it's still not wasted money.

 

Our VPs ship with a new overflow valve, so it would be a waste for a pump that will be replaced.

Check the overflow valve with a regulated air source. It's as accurate as anything. If it checks out bad, then fine, replace it. But I have yet to see an overflow valve fix a P0216 code.

Dave

 

i blew air threw it with my mouth with ease. i cant blow as good as blackdodge can though

 

Dave says he sends out new regulators with every pump and that being the case then he is the first one I have heard of doing that. So then ya, if your buyin a new pump from him the new one would be a waste of money.

 

Sounds like a bad overflow valve to me... It should hold 14 PSI of pressure before opening up. If you can blow through it by mouth then it dead...

 

Dude fix your truck and leave me out of your fantasies.