Rough idle after 150 hp injector install
#1
Rough idle after 150 hp injector install
Alright, I bought a set of six BD 150 hp injectors. I bought them from a guy who had 200s in his 2000 so he had no use for the 150s ( he had them for around a year but never installed and were always in the box, but no red tip on the injector nozzle tip. Anyway I and friend put em in with new o-rings, copper washers and connector tubes. Seems like there is 1 bad injector cuz we cracked the pressure line on #3 where it was happening, we switched #3 injector to #1 and same thing happened. Driving it works like a charm but at idle it idles rough. Any suggestions?
The following users liked this post:
geatgavi (03-09-2015)
The following users liked this post:
geatgavi (03-09-2015)
#5
If you take it to a diesel shop they can make sure they are firing under the right pressure. If one is out of adjustment you will think you have a bad/dead/something wrong injector. Especially if the guy you got them from had them on the shelf there must have been an issue as to why he didn't put them in. Otherwise why buy them?
Also Fill out your signature, so we can see what you have done to your rig.
Also Fill out your signature, so we can see what you have done to your rig.
The following users liked this post:
geatgavi (03-09-2015)
Thread
Thread Starter
Forum
Replies
Last Post
cdetterer
5.9 Liter CR Dodge Cummins 03-07
4
01-21-2015 10:47 AM
99stackedpowerstroke
Ford Powerstroke 03-07 6.0L
7
10-08-2014 07:06 PM