It will work as long as the bed you are putting on is the same size as you are taking off. But if you take the sides off the bed will look jacked up. Probably some paint fade and the areas where the fenders secure to the bed will look out of place.

 

Did you get a fuel pressure gauge to go with it?

 

No not yet I am working on that right now.

The big line kit should bump me up a few psi. That will make me feel a little better about driving it.

I will do the guage in a week or so.

The list right now is new track bar( in box waiting to go on), get it a alignment, put on big line kit.

Also I am having some issues on what to get, I know I need a snubber valve.
But then what else.
I am going to go with the glowshift
GlowShift | Tinted Series 30 Fuel PSI Gauge with Electronic Pressure Sensor - 52mm


http://www.glowshift.com/instruction...0-PSI-Fuel.pdf


I guess the pressure sensor goes right in to the snubber valve right?

thanks

 

Glowshift is junk save your money and go with ISSPRO. Are you still running stock lift pump. I don't see how adding a big line will bump it up a few PSI. There should be install instructions for your big line kit to tell you where to put your sensor.