01 2500 Dana 70 rear wheel lean?

Reply Subscribe

Thread Tools

Search this Thread

#11

01-21-2014, 10:11 PM

mysterync

Diesel Bombers Sponsor

Join Date: Mar 2007

Location: Blowing Rock,NC

Posts: 3,791

Likes: 352

Received 367 Likes on 251 Posts

Quote:

Originally Posted by ramrunner01

Well a local shop did my bearings and he said that he didn't notice anything strange when he was in there he also looked at it and didn't think the lean was anything to worry about do you think the axle would cause this problem I'm just not good at rear ends and I'm wondering if maybe the hub or axle has a problem it's hard for me to believe that tube is bent but hell idk

A hub typically as it turned Would likely wobble. It would be extremely rare to bend a axle tube. Have you checked run out and done measurements to determine how much it's leaning?

Sent from my SCH-I605 using Tapatalk 2

Reply Like

#12

01-22-2014, 11:22 AM

ramrunner01

Diesel Enthusiast

Thread Starter

Join Date: Jun 2013

Location: Kansas

Posts: 153

Likes: 5

Received 4 Likes on 4 Posts

Only with a tape measure I'm gonna put it on the alignment rack when I get new tires to see how bad it's really leaning i took a tape measure and measured both sides from frame to top of the tire but idk how accurate that really is

Reply Like