I've been looking into getting dual stacks but don't know anything about it, I want them to be cut angled at the cab to not come over it, what's the process I have to go through? Will muffler shops do it? I've heard they won't because they can't cut a hole in your bed?

---AutoMerged DoublePost---

And can I get it ran from the 4 inch turbo back I have now? Or have to get new pipe through out?

 

Most kits come with flex pipe and you can use your 4inch you have. As far as muffler shops idk i would just cut the hole in your bed mount the bottom pipe and adjust stacks so they dont go over your cab. Measure the top of your cab down your bed to see how long it is so you get stacks the right length

 

Alright thanks.

---AutoMerged DoublePost---

I'll look into it what do you advise like just using a torch to cut my bed? Or what? Can it anyway catch the diesel and blow up? Haha

 

I used a drill then jigsaw

 

Thanks for the help.

 

Try to keep the piece you cut out whole. Then it can be welded back in when your done with the stack phase and you won't have the hole in your bed for everything to fall through.