Adjusting throttle pedal
#1
Adjusting throttle pedal
My accelerator pedal has a ton of slack in it. When i push it to the floor i'm only at half throttle. Is there a way to adjust it? Its a 93 d350 auto.
---AutoMerged DoublePost---
Bump..
So nobody on this whole forum has adjusted their accelertor pedal?
---AutoMerged DoublePost---
Bump..
So nobody on this whole forum has adjusted their accelertor pedal?
Last edited by Bigdog7373; 06-03-2012 at 08:44 PM. Reason: Automerged Doublepost
#2
Find something that will clamp the cable to extend it and pull it tight to the pedal sticking out farther making it tighter. Adjust throttle linkage rod tighter at the pump "careful with the plastic ends they get brittle and break easy" , remove high idle screw, and you can move the throttle rod ball up to the higher hole on the throttle lever to help with more full throttle travel.
#4
i had that problem going over togeetee pass going to jackson hole, 3weeks ago, pulled over and noticed no power thought my injector pump dying, looked under dash at pedal and could pull the cable back from the pedal 1-1/2" pulled a mcgyver and use a 5 hour energy drink lid, cut little hole for that plastic clable stop and installed it in 15 min, was more pain in *** to hold the cable and thread it thru and place plastic cable stop back on! full pedal and now more power!!
Thread
Thread Starter
Forum
Replies
Last Post
burndiesel
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
02-07-2023 01:15 AM
Colbyflory
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
08-16-2021 09:19 AM
krinderhagen
Ford 83-94 6.9 and 7.3L General
0
12-31-2014 07:12 PM
1stgenswap
1st Generation Dodge Cummins 89-93
2
11-03-2014 09:45 PM