problems
#1
problems
Hey I just put a 3200 spring in my pump. When I started it, it was idleing a little higher than usual.
I tried giving it some throttle and it sounded like it was reving lower the more throtle I gave. If I even tap the throttle it revs really low and sounds like it's going to stall.
Before this I had the pump top off all week waiting for a part. So some of the fuel in the pump evaporated. Just figured that could have something to do with it but I wouldn't know.
As of yesterday it's now idleing rougher and lower than usual and it's making white smoke now.
Any ideas?
Thanks in advance for any suggestions.
I tried giving it some throttle and it sounded like it was reving lower the more throtle I gave. If I even tap the throttle it revs really low and sounds like it's going to stall.
Before this I had the pump top off all week waiting for a part. So some of the fuel in the pump evaporated. Just figured that could have something to do with it but I wouldn't know.
As of yesterday it's now idleing rougher and lower than usual and it's making white smoke now.
Any ideas?
Thanks in advance for any suggestions.
#3
I was pretty careful about indexing the throttle but there's a chance I messed up. It just seems like the rpm's shouldn't drop when i accelerate because of that. I'm going to try getting rid of any air in the pump or injectors. You just loosen the fuel lines until some fuel comes out to do that right?
Last edited by kqmtb2006; 01-11-2012 at 02:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post
DODGEARMYGUY
24 Valve 2nd Gen Dodge Cummins 98.5-02
5
03-03-2015 11:40 AM
JRB1960
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-01-2014 09:24 PM