rear axle problems
#1
rear axle problems
So I have a 89 dodge d350 cummins and i beleive it has the dana/spicer 70 rear axle. In order to remove the drums I have to pull the axles and remove a bearing nut. I measured it and it came out to 2 9/16 inches so I assumed it was metric. The guy at autozone looked it up and swore it was 2 1/2 inches so i bought the socket and it was a little too small. Does anyone have any experience with this? Im curios on the actual size and where to find a socket the right size. Thanks in advance.
#2
#3
I use a 2-9/16 socket bought it from the matco tool truck. it's loose on the nut but will work fine .
The thing is it is a rounded hex nut not a standard hex nut
there a pic of it
http://www.alltradetools.com/catalog...nut-socket.jpg
The thing is it is a rounded hex nut not a standard hex nut
there a pic of it
http://www.alltradetools.com/catalog...nut-socket.jpg
#8
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
12-19-2014 02:30 PM