ok guys stupid but simple question... which way should the ''ground'' side of my homemade pin should it face... as in passenger driver front back.... thanks...

 

turn it to the front

 

it should face straight out towards the front of the truck so the pin will ride on the deep part of it. when you have it to were you think it should be. push the diapham down and up a few times then take it back out. the needle should leave a line on the lip of your pin and that will give you a good idea of how straight forward you have it.

 

thanks!!!!!! did the afc smoke screw pin grind full power screw and idle adjustment today but for some reason that had slipped my mind as to which way it should face...

 

its no biggy. you take it for a ride yet?

 

oh ya...i mean it runs good for a feed truck!!!!!! wont hang with the 24 valve but.... my turbo and exhaust prob cost more than the whole 1st gen with everything done to it...