Master cylinder
#1
#2
Have you properly adjusted the back brakes?
Basically you lift the rear (both sides) then pull out the little rubber nubbin on the inside of the drum backing, and rotate the adjusting wheel (down) until they tighten up, and then loosen them till they're barely free. You might also want to bleed it all out, while you're back there, and also bleed the RWAL on the rear of the frame.
Basically you lift the rear (both sides) then pull out the little rubber nubbin on the inside of the drum backing, and rotate the adjusting wheel (down) until they tighten up, and then loosen them till they're barely free. You might also want to bleed it all out, while you're back there, and also bleed the RWAL on the rear of the frame.
Thread
Thread Starter
Forum
Replies
Last Post
bryan0702
Chevy/GMC 6.2L and 6.5L
2
03-18-2015 05:03 PM
Kennyw250
1st Generation Dodge Cummins 89-93
3
01-14-2015 07:47 PM
Diesel Bombers
General Diesel Related
0
10-31-2014 08:10 AM