is this normal what can cause this

 

if u go to far in it will get stuck mine did today

 

wont it run away if its in to far i have been driving it i was going to turn it but it wont move

 

do you have the factory seal still on the screw.

 

apparently some later model trucks have screws that are too short to get them to the point of runaway.

My truck is like that. I turned it in as far as it would go and there is still more to be had. Just too lazy to take the screw back out and lengthen it.

 

i have alot of the screw still out of the pump

 

i never seen one like that. if the seal around the screw was removed.

 

if you are talking about the o ring it is still there i just got screw out i had to use vise grips it was in as far as it would go i guess if you can call me at 419 569 5227

---AutoMerged DoublePost---

how do you lenthen screw can you just use on from older pump