wait to start light blinks and grid heater acting weird
#1
wait to start light blinks and grid heater acting weird
Ok after i cycle the grid heater, the ground wire gets real hot (wire from grid heater to intake bolt) and the wait to start light is solid until the grid is done heating, then blinks after the grids go off, and also the solenoid/relay whatevr between battery and grids will sometimes whine real loud then thunk when going off, other times its silent. I have checked for shorts and all connections are good. Im not a wiring expert either. What could all this possibly mean?
#2
#4
the reason it blinks is because you got problem somewhere. check to make sure your ground is good and tight. also make sure that your wiring going to the intake air temp sensor on the intake manifold is good as well. if those all look ok, one of your relays are probably bad. in the sticky i believe is a link on how to test them
The following 2 users liked this post by tltruckparts:
big bad diesel 416 (06-03-2010),
Billy D (06-03-2010)