1st gen chassis splice
#22
Supposed to be dealing into a 1993 E/C 1 ton rolling chassis in the next week.
Still has a rustfree cab and a set of DRW axles on it.
I've been looking a long time for a 4WD E/C frame and they are very scarce, now that I found this one, I don't "need" it.
I do also have a couple of 2wd E/C frames that could be converted over, too.
No troubles with bad rust around here.
Mark.
Still has a rustfree cab and a set of DRW axles on it.
I've been looking a long time for a 4WD E/C frame and they are very scarce, now that I found this one, I don't "need" it.
I do also have a couple of 2wd E/C frames that could be converted over, too.
No troubles with bad rust around here.
Mark.
#23
if you still need a frame
I have three different 1993 ext-cab 3/4 and one ton dodge diesel trucks/frames. I'm in the process of putting one together and the other two will probably be cut up for short iron eventually. The one that I'm probably going to use is a 3/4 ton 4x4, I measured the depth and width of the channels and they look like they are the same all the way around. I'd be willing to sell the 4x4 one ton bare frame I have for 500.00, the rear frame is in pretty decent shape, I think the front frame might be bent slightly in the bottom channel right behind the front spring perch. I'm located just north of Buffalo, NY, feel free to contact me if you are interested or want pictures, the truck is still intact right now but I will finish stripping it down if you're interested -Bob
Thread
Thread Starter
Forum
Replies
Last Post
Cdog121
1st Generation Dodge Cummins 89-93
6
11-16-2015 01:49 PM
myago92
1st Generation Dodge Cummins 89-93
3
10-17-2014 08:50 AM