Trim Holes? how to fill?
#11
long strand fiber glass, push it in and smear it around on the backside, make sure it has a good bite. it will more than likey sag a little bit but you can sand it flush and then use some regular body putty or glaze for a nice finish. done this with two trucks now, works like a charm and no cracks.
#13
take a piece of 1" or 3/4" copper pipe and cut it to a length you can work with. flatten it out with a 3lb hammer. if you have a 110 mig welder put it on its lowest setting or what a chart recomends for the type of wire it has and the thickness of the metal. put the piece of copper on the back side of the whole and make a like a tac weld and fill in the little whole. the weld wont stick to the copper. so the back side will be nice and flush then take your grinder or polishing grinder and grind the outside part of it down nice and smooth. it shouldnt warp. if it does your putting out to much heat or are welding for too long a time. if you use a polishing wheel you shouldnt have to use to much filler on it. if you do use the new bondo/glass stuff they have now. much stronger and is waterproof. good luck.
#15
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
02-20-2015 03:50 PM