I would like to do a manual to automatic transmission swap in my 1989 dodge w250 5.9l cummins. I have the 727 torque flite now and was wondering what parts would be needed to swap in a getrag 360 manual transmission.

 

You are going to need the pedals, clutch master and slave cylinder, bell housing, flywheel and bolts, clutch, cut hole in floor for shifter, crossmember, drive shaft lengthened, neutral safety switch wires re-routed, reverse light wires fitted to 5 spd, and steering column or just remove the shift handle, and above all make sure the rear yoke on the trans is good as they are not to be found!

 

I think I will just leave my 525 in that seems like a lot of rework.