Banks Manifold for 12 Valve?
#5
#8
I imagine that's a one-off prototype as you can see the individual EGT probe wells in each runner just after the head. Further, unless I'm mistaken, the CR uses round ports where as ours are rectangular.
It's a lot lighter than a cast unit being thin-wall tubing. I imagine the bellows go a long way in keeping the metal from tearing with the expansion/contraction.
I like that remote oil filter, oil-cooler cover-plate.
It's a lot lighter than a cast unit being thin-wall tubing. I imagine the bellows go a long way in keeping the metal from tearing with the expansion/contraction.
I like that remote oil filter, oil-cooler cover-plate.
Last edited by BC847; 11-26-2012 at 05:08 PM.
#9
#10
The following users liked this post:
bladeyamaha (11-27-2012)