BUSHIN FOR THROTTLE LINKAGE
#2
I'm sure how far off the pump you're talking, but you may try Cummins. I know the little rod ends on the rod are a Cummins and a Dodge part (Cummins was waaaayyy cheaper). Might go down to your local Cummins dealership and look at the computer with the guy and see what they can get. If not, you may be just as good to build some version of your own using the local boneyard and auto parts store... springs are an easy one to make or modify. Bushings may need a little creativity with plastic sleeving, bronze bearings, or cable stakes from a Lowes/Home Depot. Our throttles are pretty straightforward, the one on my Xterra is hard to look at, much less try to rig.
The following users liked this post:
bladeyamaha (11-15-2012)
#3
The following users liked this post:
bladeyamaha (11-15-2012)
Thread
Thread Starter
Forum
Replies
Last Post
Lawrence D. Sanders Sr
5.9 Liter CR Dodge Cummins 03-07
0
01-23-2015 12:47 PM