AFC Modifying Precision Questions??
#1
AFC Modifying Precision Questions??
I currently swapped in flat thin washers replacing the cupped ones, and trimmed down the AFC foot and swapped in the medium spring from the "AFC Spring kit". From my observations, I was able to trim the foot down more than 1/8 of an inch like most threads state, at full travel the foot just barely taps the end of the housing. It's set now at full travel at 35 PSI but around 17 PSI the foot still moves more than half way, more than I'd like. I can turn the star wheel out more and it will give me half foot travel at 17 PSI, but at 35, the foot is maybe about 2 mm from the housing wall...
This truck is my DD, I want the power where I can get it, but I enjoy the fuel mileage too. I don't want to be putting in too much fuel at low boost.
Does anybody have any incite on what I am asking?
Thanks!
This truck is my DD, I want the power where I can get it, but I enjoy the fuel mileage too. I don't want to be putting in too much fuel at low boost.
Does anybody have any incite on what I am asking?
Thanks!
#3
#4
#5
#6
For the foot to move half way, 10 PSI is what it takes.. and thats with the medium spring in the AFC Spring Kit.
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
General Diesel Related
0
11-28-2014 09:50 PM
Diesel Bombers
General Diesel Related
0
11-12-2014 08:10 AM