I have a bone stock 12v an got about 5k to spend what would u do?

 

Put stacks on it.

 

Lift pump injectors springs plate fuel pin auto or manual tranny?

 

Fully built auto tranny

 

What's your goals for the truck

 

yes sir x2

 

 

Cam, Valve springs, head studs, injecotors, airdog or FASS pump, governor spring kit, intake and exhuast, hopefully gauges too? At least thats what I would do with $5000

 

you need a trans/clutch first off.... good quality gauges, 5x.012 injectors, hx40 compressor upgrade, intake, exhaust... could be a stout 400hp reliable truck

 

well if the trans is fully built then Id go with a full set of guages, pyro, trans, boost, and whatever else you want. 4" exhaust- depends, air intake- homemade $100, 4gsk w/ 60lbs valve springs- $226, injectors say 5x14's- $700, turbo I would disagree with the above statement of the hx40, with 5 grand you could afford say an s300- $1000-$1500, afc mods- free, plate-$20-$30, airdog or fass-$500-$700, and maybe some head studs$220? All these prices are really general. But this will definitely put you in the 400hp and over mark. 700-900 ft/lbs torque. I run pretty much a close replica of this setup and really enjoy it. But this is just me, some other veterans might chime in with a dynamite setup for alot cheaper.