push button start?
#1
push button start?
my ignition is shot.. you have to push in super hard to get it to turn over. i was thinkin about a "turn the key to ign then push button to start". i have seen it on the 3rd gen...but has anybody done it on a 2nd gen? anybody know which wire/color to tap? thanks in advance guys
---AutoMerged DoublePost---
lookin at the wire diag....it shouldnt be hard...looks like power on one BP on the push button and either cut or splice onto the yellow wire in the ignition and i should be good... i dont suppose any body wants to check there manuel to make sure my haynes is correct on the color wire?
---AutoMerged DoublePost---
lookin at the wire diag....it shouldnt be hard...looks like power on one BP on the push button and either cut or splice onto the yellow wire in the ignition and i should be good... i dont suppose any body wants to check there manuel to make sure my haynes is correct on the color wire?
Last edited by monster12valve; 08-18-2011 at 07:44 PM. Reason: Automerged Doublepost
#2
#3
O man are you in luck, ran across this TODAY!
https://www.dieselbombers.com/24-val...n-igniton.html
AHA, got it, there ya go man. I'm pretty sure wyodiesel92 and RAWilliams can help you out if you need any more specifics.
https://www.dieselbombers.com/24-val...n-igniton.html
AHA, got it, there ya go man. I'm pretty sure wyodiesel92 and RAWilliams can help you out if you need any more specifics.
#4
Thread
Thread Starter
Forum
Replies
Last Post
Cavnar
Diesel In Distress - Support Ticket
3
09-09-2015 07:18 PM
cjgregory
Diesel In Distress - Support Ticket
0
03-31-2015 01:45 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
carid
Diesel Bombers Sponsors
0
11-18-2014 06:49 AM