2nd gen pcm interchangability?
#12
#13
#14
I would check the wiring going to it, also take a look at the sensor itself to see if it looks messed up. The gap between it and the harmonic balancer is supposed to be 0.050", so I would check that too. Other than that, I'm not sure of any other tests that you can run to see if it's bad. I'll check the FSM. Oh, also might not be a bad idea to check your ground cables. Make sure they're clean and tight.
#16
#17
OK THANKS ...IMA DO THIS IN THE MORRING...
---AutoMerged DoublePost---
ok i got everything back on ,..new steering box an crank sensor now im waiten on batt to charge back up for i can c what happen
---AutoMerged DoublePost---
STILL NO CHARGE WHAT ELES CAN IT BE.....COULD IT BE THE BLACK THING THAT U SCREW ON THE ALT
---AutoMerged DoublePost---
ok i got everything back on ,..new steering box an crank sensor now im waiten on batt to charge back up for i can c what happen
---AutoMerged DoublePost---
STILL NO CHARGE WHAT ELES CAN IT BE.....COULD IT BE THE BLACK THING THAT U SCREW ON THE ALT
Last edited by ADRIAN; 08-22-2011 at 09:26 AM. Reason: Automerged Doublepost
#18
#19
#20
hey guys im in the same boat as adrain... iv got a 97 that i swapped moters in and nothing works... no tach no speedo no charge no ac... i think my buddie hooked a wire or to up back works on start up but i got that fixed but still no tach speedo or charge or ac.. any ideas? i thinking its my pc... how much and where do i get one?
Thread
Thread Starter
Forum
Replies
Last Post
CGwill
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
01-26-2015 02:10 AM
Cumminsfreak24
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
01-21-2015 09:10 AM
myago92
1st Generation Dodge Cummins 89-93
3
10-17-2014 08:50 AM