TC LOCKUP SWITCH SCHEMATIC
#3
#4
#5
#6
The diagram i have is showing a solid orange wire coming from that middle plugin going to the transmission. According to the diagram it uses Pin 31 on that plugin. Is this the wire you're referring to?
As in the illustrations, the only wire anyone messes with to lockup the T/C is the Orange/Black wire. Nothing else is tampered with other than of course the stock tranny relay which is removed and then jumped out (as illustrated).
As in the illustrations, the only wire anyone messes with to lockup the T/C is the Orange/Black wire. Nothing else is tampered with other than of course the stock tranny relay which is removed and then jumped out (as illustrated).
Last edited by zdanman; 01-07-2011 at 06:56 PM.
#8
You are saying you spliced into the SOLID orange wire by mistake correct?
If you can, check the voltage you are getting now on the solid orange wire. You should be reading +5.0V.
The solid orange wire has to do with the governor pressure used for shifting.
Also think about resetting the computers via battery disconnect.
For a picture of it see page 11 of this PDF...
http://www.jegs.com/InstallationInst...51-1030418.pdf
Reading in some other forums I've seen other people having to mess with this wire after rebuilding their transmissions. Search for "47re pin 31". Keep us updated
If you can, check the voltage you are getting now on the solid orange wire. You should be reading +5.0V.
The solid orange wire has to do with the governor pressure used for shifting.
Also think about resetting the computers via battery disconnect.
For a picture of it see page 11 of this PDF...
http://www.jegs.com/InstallationInst...51-1030418.pdf
Reading in some other forums I've seen other people having to mess with this wire after rebuilding their transmissions. Search for "47re pin 31". Keep us updated
Last edited by zdanman; 01-07-2011 at 07:21 PM.
#9
#10
@ 12vcummins96
You spliced the wire located at Pin 25 (which is also Orange/Black) and which goes directly to the "Wait to Start" light.
You need to tap into the OTHER Orange/Black wire located at Pin 11. Double-check and remake the connection.
I'll be updating these diagrams to clarify these things.
You spliced the wire located at Pin 25 (which is also Orange/Black) and which goes directly to the "Wait to Start" light.
You need to tap into the OTHER Orange/Black wire located at Pin 11. Double-check and remake the connection.
I'll be updating these diagrams to clarify these things.
Last edited by zdanman; 01-08-2011 at 02:19 PM.
The following users liked this post:
12vcummins96 (01-09-2011)