About 6 months ago I had a rear wheel bearing go out (outer only) scratched up the axle tube I cleaned it up and replaced the bearing.Well every couple of months I'm tearing down axle to put a new axle bearing in.Also the last tear down the back of the outer bearing was completely gone eaten away and the seal was wasted.Tearing this thing down every other month is getting old and expensive

 

something is out of alignment to be doing that

 

What are you torquing everything down to and is the axle a 70 or an 80 it should be 120 to 140 ftlbs on the axel shaft nut

 

It's a dana 80.The last tear down the back of the outer bearing was eaten away,I had to clean the tube surface to get the bearing on.BTW does anyone know the speedi sleve part numbers for the dana 80 (outer bearing and seal surface).Thanks