I am about to order the single exit 4" (S6100AL), and have a question about exhaust hangers. The kit says it requires the hanger at the end of the tailpipe like the factory exhaust. Is there anyway around this, because I think that it looks terrible. If it has to have it then thats ok, but any help I could get of deleting it would be very much appreciated.

Thanks
Ryan

 

You can fab something up to make for a tight install.

 

Like putting an exhaust hanger farther up the system? Has anyone done this?

 

I have the stainless version of your exhaust and for the first month or so I didn't even have the hanger kit. I just let the tailpipe hang without the hanger. I just tacked the tailpipe on to my muffler delete and it gave me no problems

 

Awesome, that's what I wanted to hear. Would it be best for me to add another hanger

 

Yes you need a hanger back there. You can even order the bracket for a newer truck and install back there with a rubber hanger.

 

I would add a hanger somewhere esp if your using the muffler delete pipe as they don't have hangers. Maybe throw some bailing wire on the over the axle to help support it. I got tired of my tailpipe bouncing around and listening to my friends telling me how ghetto it was thats why I got my hanger.

 

thats cool, i appreciate it, i wasnt sure how much it would move, if it moved at all. thanks
again

Ryan

 

It really won't move that much but when you hit bumps it'll bounce enough to notice. If you do it just put a couple tacks on the tailpipe to keep it from falling off

 

man, you've been a big help, I really, really, did not want to run that ugly a** hanger!