stack
#1
stack
im getting a 5" stack for my truck, i want it off center to the right so it will line up. is there anything special i need to do besides get a 90 and a straight pipe and cut a hole in the bed?
---AutoMerged DoublePost---
ive also seen the exhaust come out of the hood, how and what is that?
---AutoMerged DoublePost---
ive also seen the exhaust come out of the hood, how and what is that?
Last edited by wilke12V; 10-23-2008 at 03:45 PM. Reason: Automerged Doublepost
#2
you mean you want the stack to come right up where the exhaust runs normally, then yes you will need a a piece of straight pipe to come from your down pipe and i would recomend using flexpipe also if its a regular cab i would run the flex right off the down pipe then to the straight to the 90 and up to the stack. I'll go take a picture of mine to show you some ideas
#5
any exhaust shop should be able to get it for ya, you will only need 4" since the rest of your exhaust is 4".
The order should be-Down pipe then to either a little piece of straight then to flex or just straight to flex, then enough straight to get you where the 90 will go up and to your bed then either attach the stack to the 90 if it is long enough or you may need to put another short section of pipe on the 90 to then go to the stack
The order should be-Down pipe then to either a little piece of straight then to flex or just straight to flex, then enough straight to get you where the 90 will go up and to your bed then either attach the stack to the 90 if it is long enough or you may need to put another short section of pipe on the 90 to then go to the stack
#6
Thread
Thread Starter
Forum
Replies
Last Post
hollywoodbusa
Wanted To Buy (WTB) - Used
0
02-22-2015 08:05 PM
ramrunner01
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
01-19-2015 05:01 PM