ok, fixed the truck. i was putting a mech. water temp. gauge in, and i have my pod on my dash, well after getting the truck ready for the gauge found out the probe and wire wernt long enough to put in the front of the block. my qusetions are, does anyone have a mechanical water gauge on the dash or on the A piller, if so where did you put it? and my boost gauge. like most gauges there is a peg for the pointer to rest on well mine is behind that so i cant see my boost how would i go about getting the pointer in front of the peg again? thanks

 

 

Where did you get the boost gauge and who mkaes it?

 

i ended up taking gauge out and taping it on the table to get it over the peg, boost is an autometer, and the temp gauge is sunpro, the only reason i went sunpro is cuz i didnt have the money at the time and a good match, (not dissing sunpro) the gauge works. i just moved the pod from the dash to by the tc shifter