12V high EGT and slow boost with twin turbos
#11
If the Engine is studed 18* would be great .. also .. do a cold re-torque before you start getting too far invested .. if he didnt do any re-torques .. this is the time to get it done before you end up with a leaking or blown HG .. Insurance policy
If its not studed... Get on it .. dont touch a think until its studed !!
If its not studed... Get on it .. dont touch a think until its studed !!
#12
Motor has been studded.
The pump is at 21*, thinking I will change it to 18*. Should I take it down more then that?
It has 191 DVs
Installed a DDP AFC spring which is about 1/2" longer then stock and set it to be full open at 30 PSI with shop air. Smoke screw is just touching plunger so it is at zero.
The pump is at 21*, thinking I will change it to 18*. Should I take it down more then that?
It has 191 DVs
Installed a DDP AFC spring which is about 1/2" longer then stock and set it to be full open at 30 PSI with shop air. Smoke screw is just touching plunger so it is at zero.
#14
Set the timing to 17.5* a little lower then I wanted but that was where it ended up . Will have to do some testing tomorrow and see how it goes.
#16
#18
The owner of the truck is not impressed with the 1800 RPM and is pushing me to put a single on it. If I could get it down to say 1500 RPM I could probably convince him to keep them. When your pulling it like he does, it would sure be nice to have something on the bottom end.
Maybe we are expecting to much out of twins. What is normal spool RPM for a HTB2 & S400S062 Turbo setup? What are others seeing with their twins?
#19
most guys are running the he351 or a 35/40 with the HT3b .. I will be attempting to do a 34/40 HT60 .. oughtta be fun .. will see ..
the primary could just be to damn big .. might try a HX35w out of the box with the HT3b and see how that spools .. Just a thougt .. and its failry cheep too
the primary could just be to damn big .. might try a HX35w out of the box with the HT3b and see how that spools .. Just a thougt .. and its failry cheep too
#20
most guys are running the he351 or a 35/40 with the HT3b .. I will be attempting to do a 34/40 HT60 .. oughtta be fun .. will see ..
the primary could just be to damn big .. might try a HX35w out of the box with the HT3b and see how that spools .. Just a thougt .. and its failry cheep too
the primary could just be to damn big .. might try a HX35w out of the box with the HT3b and see how that spools .. Just a thougt .. and its failry cheep too