installing cruise control on a 97
#1
#2
other than having to switch out a steering wheel, the only other thing I would worry about is the pcm, there will be two circuts for the vehicle speed control servo in connector 3 cavitys 3 and 4 tn/rd and lg/rd these are control circuts for the servo and if you don't have them in the harness this just became a much m ore exspensive job
other than that you will need a speed control servo pigtail connectors most likely and the steering wheel controls and of course hardware for the servo
very doable job
good luck
scott
other than that you will need a speed control servo pigtail connectors most likely and the steering wheel controls and of course hardware for the servo
very doable job
good luck
scott
#4
sounds like a gravy job then, I am going to be swapping a SLT extended cab onto my base model reg cab here in a few weeks, I think I will use the collum harness and do the same thing you are doing, plus a little more, if I run into any walls ill post here about it, I also think while I have the body off ill pull the motor and freshen it up and maybe a rebuild on the tranny too , who knows, I have a extra 241 HD transfer case I cannot decide weather to sell or keep for a spare
lets dooeeet
good luck man
scott
lets dooeeet
good luck man
scott
Thread
Thread Starter
Forum
Replies
Last Post
burndiesel
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
02-07-2023 01:15 AM
JBearSVT
12 Valve 2nd Gen Dodge Cummins 94-98
0
07-09-2015 06:16 PM
Cliffordthe24v
24 Valve 2nd Gen Dodge Cummins 98.5-02
1
11-06-2014 12:19 PM