wont start then will start
#21
#22
#23
#24
What do you recomend? TORK TEK CUMMINS ADJUSTABLE OVERFLOW VALVE 22 to 35psi or tork tek also has one that runs a bit higher than that but does it matter on the psi will it only go so high with a stock P7100? I pretty much have a a stocker just a S&B cold air and Exhaust. And Ill look that extention plug up as well.
---AutoMerged DoublePost---
TORK TEK CUMMINS ADJUSTABLE OVERFLOW VALVE OFV010 - Tork Teknology
http://www.torkteknology.com/product...-OFV040HP.html
---AutoMerged DoublePost---
TORK TEK CUMMINS ADJUSTABLE OVERFLOW VALVE OFV010 - Tork Teknology
http://www.torkteknology.com/product...-OFV040HP.html
Last edited by Chad96Dodge; 11-27-2012 at 10:57 AM. Reason: Automerged Doublepost
#25
Well I got it all instaled new fuel shut off, Block heater. Trucks got new life in her. Starts great. stays super warm overnight being plugged in. The fuel shut off boot on the old one was ripped pretty bad, Block heater just did not work. INFO note, being my first time doing the block heater I had no idea what to expect Lost alot of coolent ha ha! Thanks again for all the help. Gotta love the help of the Diesel Community.
#26
If your truck starts acting up with not wanting to start the first time around, check the big relay just above the shutdown solenoid... it also can cause it to not want to start each try... I pried mine apart and cleaned the contacts, stuffed it back together and it's been good for the last 2 years
Thread
Thread Starter
Forum
Replies
Last Post
Cavnar
Diesel In Distress - Support Ticket
3
09-09-2015 07:18 PM
cjgregory
Diesel In Distress - Support Ticket
0
03-31-2015 01:45 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
carid
Diesel Bombers Sponsors
0
11-18-2014 06:49 AM