Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   12 Valve 2nd Gen Dodge Cummins 94-98 (https://www.dieselbombers.com/12-valve-2nd-gen-dodge-cummins-94-98/)
-   -   Need some help white smoking (https://www.dieselbombers.com/12-valve-2nd-gen-dodge-cummins-94-98/101797-need-some-help-white-smoking.html)

95Ky5.9 09-05-2012 10:33 PM

Need some help white smoking
 
I installed a billet tappet cover roughly two weeks ago after reinstalling everything went to start but truck wouldn't start, retimed it and it started but smokes white at idle and pops if given any throttle and won't go over 1k have tried retiming a few times and have even taken pump off again to check everything but is still doing the same. Anyone have any thoughts or help?
:confused:

Sent from my DROID RAZR using Tapatalk 2

cummin_un_glued 09-06-2012 04:20 PM

how are you timing it?

biged681985 09-06-2012 04:21 PM

It sounds like your timing is way off

95Ky5.9 09-06-2012 05:06 PM

I timed it using the blue point timing kit with the dial indicator, i was goin to pin time it but as luck would have it i dropped the pump gear nut in the timing cover

Sent from my DROID RAZR using Tapatalk 2

cummin_un_glued 09-06-2012 05:53 PM

so now your taking the tin cover off to get the nut back? one thing that i have had problems with before is the timing jumping when i break the gear back loose after setting the plunger lift to what i want. any more i tighten the nut just enough to get the shaft to turn like 10ftlb maybe. also why dont ya walk us thru the steps just to make sure.

95Ky5.9 09-06-2012 06:45 PM

Yup and i usually break the nut loose before i go to set the plunger lift. But i take the intake horn and injector lines off
Take the dv holder and dv outta number 1 install the dial indicator take the oil fill off and break the pump gear nut loose, then have someone roll the engine over off the dampner til the needle bottoms out zero the dial indicator then turn the engine till the dial indicator is on the desired mm, pop the gear roll engine to tdc, reinstall washer and nut torque to 145 with someone holding the engine by the dampner to keep from spinning
Sent from my DROID RAZR using Tapatalk 2

cummin_un_glued 09-06-2012 06:52 PM

which direction are you turning the engine?

95Ky5.9 09-06-2012 07:42 PM

Goin on with the rachet sooo clockwise

Sent from my DROID RAZR using Tapatalk 2

cummin_un_glued 09-07-2012 06:55 PM

Ok...how much lift are you setting it at?

Sent with a Droid RAZR in one hand and 14,000 volts in the other.

95Ky5.9 09-07-2012 06:59 PM

7-7.1mm 19 degrees on my 175 pump i had set it there awhile back and it ran real good

Sent from my DROID RAZR using Tapatalk 2


All times are GMT -5. The time now is 03:32 PM.


© 2024 MH Sub I, LLC dba Internet Brands