Pin timed it last night and now it wont even start

Sent from my DROID RAZR using Tapatalk 2

did you varify that the pin timing also shows the correct amount of plunger lift for that pump?

also just want to make sure i got this right. all you done was pulled the pump off so that you could change the tappet cover then you put it all back together correct? didnt do anything else?

Didnt verify just tried to set it back to stockish timing to see if would run. And yes all i did was remove the pump to replace the tappet cover then reinstalled pump

Sent from my DROID RAZR using Tapatalk 2

i would think that it has to be the timing then but it sounds like your doing everything right. your not changing directions at any point while your timing it are you? you turn it clockwise till the needle bottoms out then keep turning it until you get to 7mm of lift without ever going backwards?

If i turn it backwards any we go past where we want it then turn it clockwise

Sent from my DROID RAZR using Tapatalk 2

again it sounds like you got your bases covered on the timing. have you checked the fuel system?

Besides my fuel pressure gauge at my airdog i haven't checked or been able to check anything in the fuel system besides popin injectors when the truck was runin

Sent from my DROID RAZR using Tapatalk 2

i see you have the tork tek OFV but just for giggles try clamping off the return line and see if it will start/run/rev then

Il give it a shot i was thinkin on gettin tork teks 060 since i run an ad an iv got the adjustable in now

Sent from my DROID RAZR using Tapatalk 2

yeah try it that will at least let us know that it isnt just dumping all the fuel back to the tank