7.3 littter wont start
#3
if its turning over just wont start could be fuel bowl heater blowing i think fuse 22 underhood hard to see its blown , disconnect fuel bowl heater get it in the clear re fuse fire it up
The following users liked this post:
NMKowboy (10-30-2011)
#4
tearin2deep thanks ill try that
---AutoMerged DoublePost---
Hey 95 powersmoker, The truck 179950, replaced batteries celinoids and fuel pump , moved relays around to see if other codes would pop up, I would be driving and it would all of the sudden cut power to an idle for a few then pick back up, now it just turns over, its not pumping fuel up to filter on top of engine
---AutoMerged DoublePost---
now i got a P27FE code and the P006 coming up
---AutoMerged DoublePost---
Hey 95 powersmoker, The truck 179950, replaced batteries celinoids and fuel pump , moved relays around to see if other codes would pop up, I would be driving and it would all of the sudden cut power to an idle for a few then pick back up, now it just turns over, its not pumping fuel up to filter on top of engine
---AutoMerged DoublePost---
now i got a P27FE code and the P006 coming up
Last edited by NMKowboy; 10-30-2011 at 11:02 PM. Reason: Automerged Doublepost
#5
tearin2deep thanks ill try that
---AutoMerged DoublePost---
Hey 95 powersmoker, The truck 179950, replaced batteries celinoids and fuel pump , moved relays around to see if other codes would pop up, I would be driving and it would all of the sudden cut power to an idle for a few then pick back up, now it just turns over, its not pumping fuel up to filter on top of engine
---AutoMerged DoublePost---
now i got a P27FE code and the P006 coming up
---AutoMerged DoublePost---
Hey 95 powersmoker, The truck 179950, replaced batteries celinoids and fuel pump , moved relays around to see if other codes would pop up, I would be driving and it would all of the sudden cut power to an idle for a few then pick back up, now it just turns over, its not pumping fuel up to filter on top of engine
---AutoMerged DoublePost---
now i got a P27FE code and the P006 coming up
I still don't know either of those codes, what scanner are you using? Here are the codes our trucks have and I don't see either of those on the lists...
#7
New code reader wont connect to truck , Chip programer still shows P006 code , turns over like it is going to fire, heater bowl is not filling, wait to start light comes on. Any ideas ? what to check next?
#9
check your oil those powerpokes have a murphy switch that kills them on low oil and then they wont start back up ( its similar to the dummy switches in a detroit for oil and coolant levels so the driver cant blow it up) give it a try if you havent already.
The following users liked this post:
NMKowboy (11-03-2011)