LB7 tear down
#182
#183
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes
on
109 Posts
you know, what also works well is one of those garden (Hudson) sprayers. remove the wand and connect the hose to the fuel filter. fill it with diesel and pump it up. cheap too
The following users liked this post:
4x4manonbroke (04-26-2014)
#184
the rails had air I bled them pored gas in hooked factory fuel system up with clear lines unhooked that sensor she cranked ran up 1200 oil psi ran up 80 injectors were knocking it ran about 15 sec in the middle of that time the injectors stopped knocking like it was running on fuel did that for 3-4 sec then they started knocking again and after a few more sec it died that was the most successful attempt o the 4 it is fully primed and holding it just won't fire the FICM is missing the rubber vent in it and had been pressure washed with it like this is it possible the FICM has gotten wet inside and has failed?
#185
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes
on
109 Posts
it did seem promising that it was able to run for a short bit so the FCIM may not be trashed. what about removing it and cleaning it out inside just incase? pour denatured alcohol into the vent hole and shake it around. then put it somewhere warm to dry out for a while then spray some WD-40 inside to displace any possible moisture left. i dont think it would hurt at this point.
have you got a code reader yet?
#188
#189
im not sure whats wrong yet everything seems ok but if it was ok itd run so at the moment its fully primed and holding no leaks im trying to get a scanner out here looks like she might be getting a 200 mile ride on a roll back to a dealer (ouch!) but thats all i can find and im hoping thats why its leaking it just got dry from sitting not moving oil and now that its moved oil its leaking course it shrink maybe it will swell back up and seal its not a big leak maybe an 1/2 oz
#190