kdp tab
#1
kdp tab
how thick does the kdp tab need to be I need to cut one real quick
---AutoMerged DoublePost---
i just found a peice of alluminum 1/8 thick will it work
---AutoMerged DoublePost---
never mind you guys are too slow I used a peice of 3/32
---AutoMerged DoublePost---
i just found a peice of alluminum 1/8 thick will it work
---AutoMerged DoublePost---
never mind you guys are too slow I used a peice of 3/32
Last edited by 1993firstgennewbie; 11-02-2012 at 04:25 PM. Reason: Automerged Doublepost
#2
Just about anything thicker than tin foil will work. You have to remember, its not being pressed out by anything physical. It just vibrates and shimmies around. Depending on the motor frequencies... it could vibrate out 1/8"... then vibrate in 1/4". Thats why some go right away... some take years. Just depends on how the thing resonates in its hole.
So yes. It will.
So yes. It will.
#3
I used a piece of aluminum on my 96 from an old no trespasing sign i had kickin around... idk how its held up havent taken anything apart to see.. but im guessing its good cuz i havent blown a hole in the side of my case and nothing has fallen out of the pan on oil changes!! still have the sighn and im prob goin to use the same on the 95 i just picked up...
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
51Hudson
12 Valve 2nd Gen Dodge Cummins 94-98
10
08-05-2015 12:32 AM
quiksilver1j
1st Generation Dodge Cummins 89-93
1
07-30-2015 12:41 PM