could anyone here make me a set of plugs for sizing turbo's??? i need a:

2.55
2.65
2.85
3.05

i dont care about the material, just have to have them 4 inches long, and the center 2 inches of them bored out about 2 inches deep, so they will clear the turbo shaft and fins, also if you could, engrave the sizes on the end. anyone know the exact measurements on a Aurora 5000, cause instead of a 2.85, i want it done to that number plus .05??

 

THE AUROA SHOULD SPEC OUT @ 2.8" SO THE 2.85 PLUG WILL WORK GOOD. THAT IS WHY SOME PLACES RUN A 2.8" INDUCER BORE CLASS.

GOOD LUCK!!
JASON

 

i knew they were a "2.8" but i wasnt sure if a 2.85 plug wold fit, thanks jason. how did your guy's season turn out, our season is just getting kicked off down here, it kinda sucked i missed your guys last couple pulls.

 

If you will draw me a sketch of how you want them built, I can make them for you. I have lots of aluminum scraps here I can make them out of.
JB

 

that size OD, the wall thickness needs to be about 1/8 inch with a hole bored about 2 inches deep in the center and they need to be about 3 or 4 inches long........

 

can you rough sketch about what you are lookin for not quite getting the picture and what kind of materal would they need to be made from.