Dana 60
#1
Dana 60
Not quite sure if this is the right place or not but here goes:
I can get my hands on a cheap Dana 60 full floating rear axle, but the problem is that it is only a single rear, not a dually like i want. Can i get hub extender/extensions for it? Does anyone make them, or do i need to just find a set in a junk yard to swap onto it?
Thanks
I can get my hands on a cheap Dana 60 full floating rear axle, but the problem is that it is only a single rear, not a dually like i want. Can i get hub extender/extensions for it? Does anyone make them, or do i need to just find a set in a junk yard to swap onto it?
Thanks
#2
IMHO I would find a 10.25 or 10.5 Sterling out of a newer Ford due to the strength vs. the 60. A Dana 60 rear axle is only about the size of a 9" Ford. The Sterling rear is close to the size of a Dana 80 other than the ring and pinion. Also there isn't a difference between the single or the dual wheel housing. They use the long wheel studs to be used on either.
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
KYLEBOY
Dodge Truck and Cummins Turbo Diesel Forum
0
01-18-2015 06:36 PM
gyayo2012
12 Valve 2nd Gen Dodge Cummins 94-98
7
11-15-2014 08:11 PM