ok guys, so i decided to do a little paint protection with my truck this summer, so i went and bought everything id need. I finally got around to working on it all and of some pics of my current progress. So far only the rear has been done, i will be doing some custom plasma cutting and fabricating for front side. Heres some pics.

Last night @ the shop after having too many beers and getting rear done









About 10 min ago after cleaning up stainless and cleaning rubber

 

Not too bad for beering it up as far as evenness goes!

Pass.


Drivers










Like i said, fronts will be done tonight and will have pics up as i go along. Front 2nd gen inner fenders are a bitch and a half with the protruding plastic.

 

Nice Pictures, real clean truck, those flaps will sure help keep the salt and snow off the body. Are they stiff enough to keep from flapping forward and catching the tire on those through bolts?

 

no theyre a flexible rubber but i may just cut the excess threads off.

 

Look good man.

I still think your rear bumper needs a dent in it though -

 

or not

 

The stainless braces.... did you buy or make those? Where? Looks real good!!!

 

i bought them from Bosselmans in Altoona, IA.

Front flaps are on, will get pics tomorrow after i clean them up some.

 

Looks good man! Bosslemans is a pretty nice truck stop too had been there a few years back when i was still driving

 

ok guys, heres pics of the fronts finished. I took everyones advice, rounded the edges around the weights and shortened the bolt on the backside of the weights on the bottom of all 4 flaps.

Heres pics.











Pass.


Drivers






Notice! No more long bolts on bottoms of mud flaps (next 4-5 pics)