Tried to clean up the engine bay
#1
Tried to clean up the engine bay
Well, I finally got around to painting my twins piping and polishing the comp housing on my secondary and started the valve cover and intake horn. The turbo was alot more than I was expecting. It took me forever to get the cast marks and letering off but it turned out sorta ok I guess. I need to hit it some more but I just lost focus:Cheer:. I started the air horn and valve cover lettering but didnt make it too far on them. I still have alot to do but the under hood section will someday look as good as it runs:hehe:. Any tips to make this easier? I plan to do the primary too I guess I should have practiced on it first.
#3
The engine was spotless about 1 1/2 hours before those pics. I took it down to the shop and simple green'ed the crap out of it and hit it with the mega psi washer. I tried to do a little more on the valve cover and intake horn after that and got aluminum and junk everywhere.
Last edited by 2141pete; 02-16-2009 at 09:29 PM. Reason: I forgot to put the "en" in engine.
Thread
Thread Starter
Forum
Replies
Last Post
burndiesel
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
02-07-2023 01:15 AM
Gm3500
Chevy/GMC 6.2L and 6.5L
9
05-07-2015 11:01 AM
metal_miner
Diesel Engine Conversions
7
12-23-2014 11:40 PM